![bmw ista ethernet zgw bmw ista ethernet zgw](http://www.car-auto-repair.com/wp-content/uploads/2020/12/E-sys-Perform-Remote-Coding-for-BMW-Through-VPN-Gateway-12.jpg)
Or here is another alternative way after you click the Setting button and select “VCI Config” tab:Ĭhoose “HO-ICOM ENET direct connection” option and set ENET mode with empty IP-Address. Select your ENET connection from the list and click “Set up connection”.Īnd just wait the vehicle identification process complete! Select “Read out Vehicle Data” tab and click “Complete Identification”. Select “VCI Config” tab and “HO-ICOM ENET local and ISIS network” option, click the OK button.īack to main menu and click the Operations button. Turn on car ignition and run BMW ISTA Rheingold. Uncheck the box “Connect a host virtual adapter to this network”. Open Virtual Network Editor and disconnect form the host all adapters with Subnet Address 169.254.0.0.
#Bmw ista ethernet zgw install#
Or if you install ISTA in VMWare, try this way: Version 1.
#Bmw ista ethernet zgw software#
Select Internet Protocol Version 4 (TCP / IP) and click the Properties button.Įnter 169.254.1.1 for the IP address and 255.255.0.0 for the subnet mask then press the OK button. Here’s the instructions for operating BMW Diagnostic Tool EDIABAS software applications under use the ENET cable Ethernet connection. Select the Ethernet that is connected to the vehicle and open the Properties screen. I did everything correct and it still failed. Trust me I know my way around vvdi prog vvdi2 and ISTA+ but I always stay away from esys. Newest BMW Rheingold ISTA-D 4.12.12 ISTA-P 3.65.0.500 DownloadĪnd here is a collection about BMW Coding/Programming,check it here: BMW Coding/ProgrammingĬonnect your laptop/PC with vehicle using the ENET cable.Īfter that, go to Control Panel→ Network and Internet→ Network Connections. (31-08-2021, 00:31 AM) PIETRO20053 Wrote: The think is it showed that it was available. Keep the port the same, just put the IP where the 127.0.0.1 is. You need to use iTool radar to read the ICOM IP address and enter it into the box in esys connection window that says ICOM/Ethernet. Here is a guide to show you how correctly connect and set up BMW ENET Cable with BMW ISTA Rheingold software! It is the first step to use this cheap BMW F Series coding cable instead of ICOM!īMW ENET (Ethernet to OBD) Interface Cable That’s because the ICOM won’t see the ZGW/VIN readout in esys.